Do you need a water heater repair in Salem, Oregon?
Are you having a problem with your electric water heater? Do you have any idea about water heaters maintenance and repair? Well, you come to the right place.
- Providing not enough hot water
- Having no hot water at all
- Producing smelly water
- Having a noisy water tank
- Having a leaking tank
Those are the most common water heater issues that you might encounter. Before going further, consider the following safety precaution steps.
Safety Precaution Steps Before Doing Water Heater Repairs:
- Turn off the water heater power by turning off the circuit breaker or fuse.
- Turn the gas valve into the “pilot” setting.
- Turn off the water supply.
- Have a second person around that can help and watch over you.
Here are tidbits of information on how to repair water heater common problems.
Simple Ways to do Water Heater Repairs:
Not heating sufficient water
What is wrong with the water heater not providing ample hot water? The unit could be too small to meet your household demand. Make sure the amount of hot water you need does not exceed the capacity of your water heater. If your needs are high for the water radiator capacity, try to limit the length of showers or install a low-flow showerhead and assign the dishwashing and laundry to different times of the day.
Not heating water
What causes a water heater that is not heating water at all? It merely implies either insufficient power or failure of one or more of its heating elements.
To begin with, check the water heater’s circuit breaker within the service panel to make sure it hasn’t tripped. In case the breaker has tripped, switch it off, then switch it back on again. If the heater’s breaker did not trip, try to reset the high-temperature limit on the radiator. If that doesn’t solve the issue, test each heating element, and replace it.
Producing smelly water
Bacteria can cause smelly hot water. To solve this, try replacing your anode rod. Anode rod protects your water heater from rusting. As time passes, it corrodes instead of your water heater, but sometimes this can lead to a reaction between the rod and sulfate from the water that causes the water to stink. Checking and replacing the anode rod at this point is a good practice.
Another way to solve this is by adding hydrogen peroxide to your water heater to eliminate anaerobic bacteria. Just flush your tank and filled it with hydrogen peroxide. Allow it to sit for two hours. After that, clean your water heater again with clear water and refill it. Is the smelly water still linger? Don’t wait too long to call the attention of the plumbing contract.
Loud noises inside your water heater tank mean there is a sediment buildup in the bottom of your heater. The presence of sediment can then move around your tank, which causes loud noise. It can lead to a significant problem when neglected. In that case, consider flushing your water heater out regularly to put all the sediments away. Also, installing a water softener in your house can be an excellent option to eliminate the residue build up in your tank.